#Audioswitcher two system tray icons install
#Audioswitcher two system tray icons manual
#Audioswitcher two system tray icons code
#Audioswitcher two system tray icons Bluetooth

Then locate the sensor you want to edit, and press the pencil icon for that sensor on the right.

#Audioswitcher two system tray icons code

This is done by pressing the small grey bar at the top of the home screen, then going to Settings > Advanced > enter in the Master, Installer or Dealer Code > Installation > Devices > Security Sensors > Edit Sensor. Remember, it is also possible to disable chimes for individual sensors. The chime setting can be re-enabled at any time if needed. Press the picture of the house at the bottom of the screen to exit the menu and return to the main screen.

This will disable all chimes for the alarm system. This will take the system into the Sound Settings Menu. Choose Settings > Advanced Settings > enter in the Master, Installer or Dealer Code (defaults are 1234, 1111, 2222 respectively) > Sound. Press the small grey bar at the top of the screen. Start from the home screen of the Qolsys IQ Panel 2. #6.To disable all chimes for a Qolsys IQ Panel 2 System, complete the following steps: When an invalid code is entered, the build-in camera takes a picture of the person and saves it in the “SETTINGS” section. These photos are tagged with a username of the individual’s code, as well as a date and time stamp. When someone disarms the panel manually, the built-in camera takes their picture and stores it in their ARM/DISARM section.

When someone disarms a system or enters an invalid code, where are the pictures stored? Disarmed Photos To see the status, simply navigate to the systems page.

When the messages appear on your phone and IQ Panel, ensure the numbers match and touch “Pair” on each.

Touch “ADD DEVICE” The panel will begin searching for new devices in range (It may take up to 60 seconds).

To connect your phone, follows these steps:

#Audioswitcher two system tray icons Bluetooth

You can use Bluetooth to automatically disarm your Qolsys Panel 2 system from an “Armed Away” status when you get within range.

To do this, just login to your mobile app on your smart device and press the “disarm” icon. You can also disarm your system even when you are away. *Note: When the system is manually disarmed, the panel will take a picture of the person with the date, time, and name of the user. If you fail to enter a valid code within the time limit, an alarm will trigger. After pressing the icon, you’ll need to enter a valid code. You can manually disarm your panel by touching the icon in the center of the screen. There are several convenient ways to disarm your system: Manually If you’re arming your system and you don’t want to arm all of your sensors, simply press the circle next to the system to successfully bypass it. How can I bypass certain sensors when arming the system? If you accidentally signaled an emergency panic signal, simply press the “cancel” X button, then enter a valid user code. How can I cancel an emergency panic signal? *Note: It’s important to note that depending on where you are, not all options may be made available. To do this, simply press the icon in the bottom right corner and select the appropriate emergency.

#Audioswitcher two system tray icons manual

If you need need to send a police, fire, or a medical emergency but your system isn’t armed, you can send a manual emergency panic signal. If my system is not armed, can I still send an emergency signal? Qolsys Panel 2 System: Top FAQs Answered #1. Let’s run through the top 10 frequently asked questions about this sleek-looking panel, so you can learn even more about this security device and utilize all of its amazing features.

#Audioswitcher two system tray icons install

Did you just install the Qolsys Panel 2 system, or are you looking to add this to your home or office security system?